90563738 NST1024.qxd: chainsaw booklet new 5/25/10 1:13 PM Page 6

2b) When charging is complete the green LED will go off.

3.Unplug charger, and remove the battery pack. Place the battery pack into the tool until it “clicks” into place.

NOTE: To remove the battery pack, press down on the release button on the back of the battery pack and slide out.

IMPORTANT CHARGING NOTES

1.After normal usage, your battery pack should be fully charged in 9 to 11 hours. If the battery pack is run-down completely, it may take up to 11 hours to become fully charged. Your battery pack was sent from the factory in an uncharged condition. Before attempting to use it, it must be charged for at least 11 hours.

2.DO NOT charge the battery pack in an air temperature below +40°F(+4.5°C), or above +105°F (+40.5°C). This is important and will prevent serious damage to the battery pack. Longest life and best performance can be obtained if battery pack is charged when air temperature is about 75°F (24°C).

3.While charging, the charger may hum and become warm to touch. This is a normal condition and does not indicate a problem.

4.If the battery pack does not charge properly—(1) Check current at receptacle by plugging in a lamp or other appliance. (2) Check to see if receptacle is connected to a light switch which turns power off when you turn out the lights. (3) Move charger and battery pack to a surrounding air temperature of 40°F (+4.5°C) to 105°F (+40.5°C). (4) If the receptacle and temperature are OK, and you do not get proper charging, take or send the battery pack and charger to your local Black & Decker service center. See Tools Electric in yellow pages.

5.The battery pack should be recharged when it fails to produce sufficient power on jobs which were easily done previously. DO NOT CONTINUE using unit with its battery pack in a depleted condition.

6.The battery pack will reach optimum performance after being cycled 5 times during normal usage. There is no need to run the battery pack down completely before recharging. Normal usage is the best method of discharging and recharging the battery pack.

6

READ ALL INSTRUCTIONS

Do not incinerate the battery pack even if it is severely damaged or is completely worn out. The battery pack can explode in a fire.

Do not charge or use battery in explosive atmospheres, such as in the presence of flammable liquids, gases or dust. Inserting or removing the battery from the charger may ignite the dust or fumes.

If battery contents come into contact with the skin, immediately wash area with mild soap and water. If battery liquid gets into the eye, rinse water over the open eye for 15 minutes or until irritation ceases. If medical attention is needed, the liquid is a 25-35% solution of potassium hydroxide.

Contents of opened battery cells may cause respiratory irritation. Provide fresh air. If symptoms persists, seek medical attention.

WARNING: Burn hazard. Battery liquid may be flammable if exposed to spark or flame.

Charge the battery packs only in Black & Decker chargers.

DO NOT splash or immerse in water or other liquids.

Do not store or use the tool and battery pack in locations where the temperature may reach or exceed 105°F (40˚) (such as outside sheds or metal buildings in summer).

WARNING: Never attempt to open the battery pack for any reason. If battery pack case is cracked or damaged, do not insert into charger. Do not crush, drop or damage battery pack. Do not use a battery pack or charger that has received a sharp blow, been dropped, run over or damaged in any way (i.e., pierced with a nail, hit with a hammer, stepped on). Damaged battery packs should be returned to service center for recycling.

CAUTION: When not in use, place tool on its side on a stable surface where it will not cause a tripping or falling hazard. Some

tools with large battery packs will stand upright but may be easily knocked over.

Battery Cap Information

A battery storage and carrying cap is provided for use whenever the battery is out of the tool or charger. Remove cap before placing battery in charger or tool.

Battery Cap

WARNING: Fire hazard. Do not store or carry battery so that metal objects can contact exposed battery terminals. For example, do not place battery in aprons, pockets, tool boxes, product kit boxes, drawers, etc., with loose nails, screws, keys, etc. Transporting batteries can possibly cause fires if the battery terminals inadvertently come in contact with conductive materials such as keys, coins, hand tools and the like. The US Department of Transportation Hazardous Material Regulations (HMR) actually prohibit transporting batteries in commerce or on airplanes (i.e., packed in suitcases and carry-on luggage) UNLESS they are properly protected from short circuits. So when transporting individual batteries, make sure that the battery terminals are protected and well insulated from materials that could contact them and cause a short circuit.

STORAGE RECOMMENDATION

1.Store tool:

a.) with the battery pack removed and on the charger.

b.) in a place that is cool and dry away from direct sunlight and excess heat or cold.

c.) out of the reach of children.

2.For prolonged storage such as over the winter, the battery pack should be fully charged and then removed from the charger. It should be charged again just prior to use.

7

LEAVING THE BATTERY PACK IN THE CHARGER

It is OK to leave battery packs on charge for long periods of time. The charger has a maintenance mode which gives the battery pack enough charge to stay “topped off”. If however, the tool is not expected to be needed for more than 30 days, unplug the charger and store battery pack in a cool, dry location. NOTE: A battery pack will lose its charge when kept off of the charger. If the battery pack has not been kept on maintenance charge, it may need to be recharged before use. A battery pack may also lose its charge if left in a charger that is not plugged into an appropriate AC source.

18 AND 24 VOLT BATTERY PACKS

The NST1024 trimmer accepts the following 18 and 24 volt Black and Decker battery packs: 24V battery (Model HPNB24) and 18V batteries (Models HPB18-OPE and 244760-00).

NOTE: This trimmer will also accept B&D 18V slide packs.

Page 4
Image 4
Black & Decker AF-100, 90563738, NST1024 instruction manual Read ALL Instructions, Battery Cap Information

NST1024, AF-100, 90563738 specifications

The Black & Decker NST1024 is a strong contender in the world of cordless string trimmers, designed to meet the needs of homeowners and landscaping professionals alike. This lightweight model weighs just around 5.5 pounds, making it easily maneuverable for extended periods. Its 24-volt lithium-ion battery offers reliable power and extended run time, enabling users to tackle larger yards without worrying about running out of charge mid-task.

One of the standout features of the NST1024 is its automatic feed spool (AFS) technology. This innovative feature eliminates the need for manual feeding, ensuring that the cutting line is always at optimal length for maximum efficiency. As the line wears down, the AFS system automatically releases additional line, allowing users to focus on their trimming tasks without interruptions.

The Black & Decker NST1024 is equipped with a 12-inch cutting swath, providing a good balance between maneuverability and coverage. This size is particularly advantageous when working in tight spaces or around flower beds and ornamental landscaping. The adjustable height is another practical feature; users can customize the trimmer’s height for comfort and optimal control, reducing fatigue during longer sessions.

Another noteworthy characteristic of this model is its convertibility. The NST1024 can easily transition from trimming to edging with a simple rotation of the handle, showcasing its versatility for various landscaping tasks. This dual-functionality not only saves time but also minimizes the need for multiple tools.

Additionally, the NST1024 is designed with a soft grip handle, enhancing comfort during use and reducing vibrations. The lightweight design combined with ergonomic features maximizes ease of use, making it ideal for users of all experience levels.

Black & Decker has long been recognized for its durability and reliability, and the NST1024 upholds this reputation. The robust construction ensures longevity, while the ease of use facilitates the perfect trim every time. Overall, the Black & Decker NST1024 truly stands out in the cordless string trimmer market, combining innovative technology with user-friendly features to create an efficient and practical gardening tool.