| 3. Press the | to generate a burst |
X | of steam (F). For best performance, leave an interval | |
MA | of 5 seconds between bursts. |
|
|
| |
| Important: Always stand the iron on its heel rest when | |
F | powered on but not in use. |
|
4. When finished ironing, turn the
the dry/steam selector to 
and unplug the iron.
Vertical Steam
Use for removing wrinkles from hanging clothes and drapes.
1. Make sure the water tank is filled to the MAX mark and iron is plugged into electrical outlet.
Care and Cleaning
This product contains no user serviceable parts. Refer service to qualified service personnel.
CLEANING OUTSIDE SURFACES
1.Make sure iron is unplugged and has cooled completely. Wipe the soleplate and outer surfaces with a soft cloth dampened with water add mild household detergent. Never use abrasives,
2.After cleaning, steam iron over an old cloth to remove any residue from the steam vents.
AUTO CLEAN® System
To keep the steam vents free of any buildup, about once a month follow these
M
A
X
AU
T
O
C
L
E
A
N
G
2.Hang the garment to be steamed on a clothes hanger. (Curtains or drapes can be steamed once they are hung.)
3.Set the dry/steam selector to desired steam level 
.
4.Hold the iron close to, but not touching, the fabric.
5.Pull the fabric tight in your free hand and pump the surge-
instructions.
1.Fill the water tank well below the MAX line. Plug in the iron.
2.Select fabric temperature setting 6 and stand the iron on its heel rest.
3.Unplug the iron and hold over a sink with the soleplate facing down.
4. Press and hold the AUTO CLEAN® button. Be careful, as |
hot water and steam will come out of the steam vents (K). |
Continue to hold the AUTO CLEAN® button until all the |
MAX 
H
SPRAY
You can use spray at any setting (H).
1.Open the
2.Fill water tank up the MAX mark.
3.Press the 
button to spray water as you iron.
water has emptied. If necessary, rock iron side to side and |
front to back. |
5. When finished, release the button, stand the iron on its |
heel rest and plug it in. Heat for about 2 minutes to dry |
out any remaining water. |
STORING YOUR IRON
4.If spray is weak, pump the button a few times.
DRY IRONING
1.Make sure the dry/steam selector is set to 
. You may want to empty the water(see “Emptying Water Tank After Ironing - Optional”).
2.Turn the
EMPTYING WATER TANK AFTER IRONING (OPTIONAL)
Note: It is not necessary to empty the water after each use.
1.Turn the 
. Unplug the iron and let it cool.
2.Open the
2. Empty the water by holding the iron over a sink with the tip pointing down. Water will empty out of
J
1.Unplug the iron and allow it to cool.
2.Set dry/steam selector to 
.
3.Store vertically on its heel to prevent water leaking from the soleplate.
11 | 12 |
