TRIGGER SWITCH & REVERSING BUTTON (FIGURE C)
• ThedrillisturnedONandOFFbypullingandreleasing
the trigger (1).
• Aforward/reversecontrolbutton(2)determinesthe
direction of the tool and also serves as a lock off button.
• Toselectforwardrotation,releasethetriggerswitchand
depress the forward/reverse control button to the left.
• Toselectreverse,depresstheforward/reversecontrol
button the opposite direction.
• Toavoidbeingturnedonaccidentally,donotcarryinyour
pocket.
NOTE: The center position of the control button locks the tool in the off position.
When changing the position of the control button, be sure the trigger is released.
SCREW DRIVING
For driving fasteners, the foward/reverse button should be pushed to the left. Use reverse
(button pushed to the right) for removing fasteners. When moving from forward to reverse,
or vice versa, always release the trigger switch first. Release trigger when the fastener is at
the desired depth.
NOTE: For best performance, use 2” fasteners or smaller, or
screwintopre-drilledholes.
NOTE:
The impact mechanism of the screwdriver creates a
loud, impacting noise when extra force is needed. This noise
is normal; t
he screwdriver is not malfunctioning or broken.
IMPACT DRIVER WARNINGS:
•Holdthetoolasshowninfigure D.
•Donotusetoolasaprybar.
•Toavoidbeingturnedonaccidentally,donotcarryinyour
pocket.
ON BOARD BIT STORAGE (FIGURE E)
Amagneticbitholder(4)isbuilt-intotheareaontopofthe
screwdriver for easy storage and access.
DRILLING
•Usesharpdrillbitsonly.
•Screwdriverisidealforbits1/4”orsmaller.
•Supportandsecureworkproperly,asinstructedinthe
Safety Instructions.
•Useappropriateandrequiredsafetyequipment,as
instructed in the Safety Instructions.
•Secureandmaintainworkarea,asinstructedintheSafetyInstructions.
•Applypressureinastraightlinewiththebit.Useenoughpressuretokeepthebitbiting
but not so much as to stall the motor or deflect the bit.
•DONOTCLICKTHETRIGGEROFASTALLEDSCREWDRIVEROFFANDONINAN
ATTEMPT TO START IT. DAMAGE TO THE SCREWDRIVER CAN RESULT.
•Minimizestallingonbreakthroughbyreducingpressureandslowlydrillingthroughthe
last part of the hole.
•Keepthemotorrunningwhilepullingthebitoutofadrilledhole.Thiswillhelpreduce
jamming.
•Make sure switch turns screwdriver on and off.

MAINTENANCE

Use only mild soap and damp cloth to clean the tool. Never let any liquid get inside the
tool; never immerse any part of the tool into a liquid.
IMPORTANT: To assure product SAFETY and RELIABILITY, repairs, maintenance and
adjustment (other than those listed in this manual) should be performed by authorized
service centers or other qualified service personnel, always using identical replacement parts.
7
E
D
C
1
2