Safety of others
uThis appliance is not intended for use by per- sons (including children) with reduced physical, sensory or mental capabilities, or lack of experi- ence and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
uChildren should be supervised to ensure that they do not play with the appliance.
Residual risks
Additional residual risks may arise when using the tool which may not be included in the enclosed safety warnings. These risks can arise from mis- use, prolonged use etc. Even with the application of the relevant safety regulations and the imple- mentation of safety devices, certain residual risks can not be avoided. These include:
uInjuries caused by touching any rotating/moving parts.
uInjuries caused when changing any parts, blades or accessories.
uInjuries caused by prolonged use of a tool. When using any tool for prolonged periods ensure you take regular breaks.
uImpairment of hearing.
uHealth hazards caused by breathing dust devel- oped when using your tool (example:- working with wood, especially oak, beech and MDF.)
Label on the tool
The following symbols are shown on the tool:
Warning! In order to reduce the risk of injury, the user must read the manual.
Date code position (Fig. D)
The date code (12) is printed on the housing of the tool, which also contains the year of manufacture. For example: 2013 XX JN
Year of manufacture
Electrical safety
Double insulation measures are taken in this power tool, so no grounding is needed. Please check whether the voltage of power supplied is consistent with the voltage on the nameplate or not.
ENGLISH
uIf the wire is damaged, it should be replaced by the manufacturer or a service center authorized by Black & Decker, to avoid danger.
Part name
The power tool includes some or all of the following parts:
1.Switch
2.
3.Modes selector
4.Tool chuck (tool holder)
5.Sleeve
6.Side handle
7.Depth stop
8.Bottom cover
Assembly
Warning! Before assembly, please ensure that the power tool is powered off and the power plug of the tool is unplugged from the power source.
Install the side handle
Warning! When holes are drilled in the concrete, bricks and other surfaces, please grip the side han- dle to ensure safe operation.
uThe side handle (6) can be rotated to any side, which can facilitate the use of the power tool in any position.
uRotate the side handle (6) counterclockwise, to unlock and release the power tool, rotate it to the desired position.
uRotate the side handle clockwise to tighten it adequately.
Fitting an accessory (Fig. A)
uPlease clean the drill shank and lubricate the drill bit before installing it.
uPull back and hold the
uPull back and hold the drill sleeve(5) clamp, you can remove the drill bit.
Use
Warning! Please use the power tool under normal load; no overloading is permitted.
Warning! Before drilling holes in the wall, floor or ceiling, please check the positions of the wire and
5
