![](/images/new-backgrounds/1259363/25936321x1.webp)
•Remove the piece of wood.
•Pull the plunge lock lever (4) up and let the router return to its original position.
•After switching the router on, plunge it down and make the desired cut.
Adjusting the revolver depth stop (fig. K)
After turning the revolver depth stop to the desired setting, you can
•Turn the depth stop screw (31) up or down as required using a screwdriver.
Setting the speed
•Set the speed control knob (3) to the required speed. Use a high speed for small diameter router bits. Use a low speed for large diameter router bits.
Using a batten as a guide (fig. L)
When it is not possible to use the edge guide, for example when routing grooves in the back panel of a bookcase to support shelves, proceed as follows:
•Select a piece of wood with a straight edge to use as a batten.
•Place the batten onto the workpiece.
•Move the batten until it is in the correct position to guide the tool.
•Securely clamp the batten to the workpiece.
Using the template guide (fig. D)
The template guide can be used to make a cutout shape from a template, for instance a letter.
•Secure the template over the workpiece with
•The router bit must extend below the flange of the template guide, to cut the workpiece in the shape of the template.
ENGLISH
Using the distance piece (fig. E)
The distance piece can be used for trimming wooden or laminate vertical projections.
Using the centring pin (fig. F)
The centring pin can be used to cut out circular patterns.
•Drill a hole for the point of the centring pin in the centre of the circle to be cut.
•Place the router on the workpiece with the point of the centring pin in the drilled hole.
•Adjust the radius of the circle with the bars of the edge guide.
•The router can now be moved over the workpiece to cut out the circle.
Using the copy follower (fig. G)
The copy follower helps to maintain an equal cutting distance along the edge of irregularly shaped workpieces.
•Place the router on the workpiece at the desired distance from the edge to be copied.
•Adjust the bars of the edge guide until the wheel is in contact with the workpiece.
Switching on and off
Switching on
•Keep the
•Release the
Switching off
•Release the on/off switch.
Warning! Always operate the tool with both hands.
Hints for optimum use
•When working on outside edges, move the tool counterclockwise (fig. M). When working on inside edges, move the tool clockwise.
11