•Children should be supervised to ensure that they do not play with the appliance.
Residual risks.
Additional residual risks may arise when using the tool which may not be included in the enclosed safety warnings. These risks can arise from misuse, prolonged use etc.
Even with the application of the relevant safety regulations and the implementation of safety devices, certain residual risks can not be avoided. These include:
•Injuries caused by touching any rotating/moving parts.
•Injuries caused when changing any parts, blades or accessories.
•Injuries caused by prolonged use of a tool. When using any tool for prolonged periods ensure you take regular breaks.
•Impairment of hearing.
•Health hazards caused by breathing dust developed when using your tool (example:- working with wood, especially oak, beech and MDF.)
Labels on tool
The following pictograms are shown on the tool:
Warning! To reduce the risk of injury, the user must read the instruction manual.
Electrical safety
This tool is double insulated; therefore no earth wire is required. Always check that the power supply
corresponds to the voltage on the rating plate.
•If the supply cord is damaged, it must be replaced by the manufacturer or an authorised Black & Decker Service Centre in order to avoid a hazard.
Features
1.On/off switch
2.
ENGLISH
3.Variable speed control knob
4.Plunge lock lever
5.Spindle lock button
6.Collet
7.Revolver depth stop
8.Chip deflector
9.Depth stop bar
10.Depth of cut scale
11.Dust extraction adaptor
Assembly
Warning! Before assembly, make sure that the tool is switched off and unplugged.
Fitting a router bit (fig. A)
•Remove the chip deflector (8).
•Keep the spindle lock button (5) depressed and rotate the spindle until the spindle lock fully engages.
•Loosen the collet nut (12) using the spanner provided.
•Insert the shank of the router bit (13) into the collet (6).
Make sure that the shank protrudes at least 3 mm from the collet as shown.
•Keep the spindle lock button (5) depressed and tighten the collet nut (12) using the spanner provided.
Fitting the edge guide (fig. B)
The edge guide helps to guide the tool parallel to an edge.
•Fit the bars (14) to the edge guide (15) using the two screws (16) provided.
•Insert the bars (14) into the router base as shown.
•Set the edge guide to the required distance.
•Tighten the fixing screws (17).
9
