![](/images/new-backgrounds/1150902/15090223x1.webp)
Continue frame assembly
You will need: caster frame and wheel frame.
Place the caster frame onto the tabs of the left frame, so that the swing table locking bracket (1) is to the rear. Place the wheel frame onto the tabs of the right frame, so that the swing table locking bracket is to the rear
(2). The leg tabs must be on the inside of the frames.
(1)
Add front panel
You will need: frame assembly, front panel, two 1/2 inch bolts, two nylon washers, and a 7/16 or adjustable spanner.
Place the front panel with the matchlight hole(1) down and to your right against the inside frame assembly as shown in illustration.
Add washer to bolt. Insert bolt through the front panel and into the frame. Insert bolt on other end through the front panel and the frame. Tighten bolts.
(1)
Add back panel
You will need: frame assembly, back panel, two 1/2 inch bolts, two nylon washers, and a 7/16 or adjustable spanner.
Place the back panel against the inside frame assembly as shown in illustration.
Add washer to bolt. Insert bolt through the back panel and into the frame. Insert bolt on other end through the back panel and the frame. Tighten bolts.
Complete frame assembly
You will need: partial frame assembly, two frame connectors, four 2 inch bolts, four nylon washers and a 7/16 inch or adjustable wrench. Hold one frame connector between the caster frame and wheel frame. Add the nylon washer to the bolt. Insert the bolt through the frame and screw into frame connector. Tighten bolt with wrench.
Repeat procedure with the other frame connector.