![](/images/new-backgrounds/1150902/15090227x1.webp)
Install manifold brackets
The manifold brackets(2) are already in place on the manifold between the valves.
Place your hand underneath the manifold. Lift the manifold and cooking box slightly and hook the manifold bracket(2) onto the frame brace(1).
(1)(2)
Install cylinder panel
You will need: Cylinder panel, two 1 3/4inch bolts, two nylon cylinder glides, two nylon washers a 7/16 inch or adjustable wrench and pliers.
Insert the cylinder panel tabs(1) into the slots in the
frame brace(2). | (2) |
(1)
Slide the cylinder panel up until notch at bottom of panel fits over the cross brace(1). Add nylon washer to bolt and insert through the hole in the wheel frame at the bottom right of the cylinder panel, make sure that the bolt slips through the hole in the cylinder panel. Add nylon cylinder glide to bolt end and tighten bolt with the wrench, while holding the cylinder glide with the pliers. Repeat procedure with the hole on the bottom left side of the cylinder panel.
(1)
Add fuel gauge
You will need: fuel gauge, two wing nuts and two nylon washers.
1)Slip the bolts on the back of the fuel gauge through the two small holes in the cylinder panel.
2)Add washers to the bolts, then wing nuts, and tighten with your fingers.
(1) | (2) |