Assembly

 

Components and Hardware Needed:

Qty

Hex Wrench 5mm (provided)

1

Rapid Downfeed Handle Shafts

3

Rapid Downfeed Handle Knobs

3

Table Crank Knob

1

Open End Wrench 916"

1

To install the rapid downfeed handles:

 

1.Screw each knob onto the shaft end with the longest thread pattern.

2.Screw the resulting handle assembly into the threaded holes on the rapid downfeed control base (see Figure 10).

Control

Base

Shaft

Knob

Figure 10. Rapid downfeed handles installed in

control base.

3.Use a 916" wrench to tighten the shaft to the control base.

G9749 Variable Speed Drill Press

To install the table crank handle:

1.Screw the table crank handle into the thread- ed hole on the table crank (see Figure 11).

Handle

Table Crank

Set Screw

 

Figure 11. Table crank handle installed.

2.Use a 5mm hex wrench (provided) to tighten the set screw in the end of the handle.

-15-

Page 17
Image 17
Grizzly G9749 owner manual Assembly, Components and Hardware Needed Qty, To install the rapid downfeed handles