•Remove the fan cover from the bottom of the power head by pressing the spring loaded release button (located on the back of the power head) and pulling the cover off (figure 7).
7
•Attach the vacuum tube assembly to the power head (figure 8) by locating the assembly as indicated by arrow, then pivot about this point until the locking/release catch is fully engaged.
REMOVING BLOW TUBE, VAC TUBE OR COLLECTION BAG (FIGURE 7 & 9)
• Toremove the blow tube, vac tube or shoulder collection bag, depress the release button on the power head and pull straight off (figure 7 & 9).
OPERATION
USE AS A BLOWER:
ALWAYS WEAR SAFETY GLASSES. WEAR A FILTER MASK IF THE OPERATION IS DUSTY. USE OF RUBBER GLOVES AND SUBSTANTIAL FOOTWEAR IS RECOMMENDED WHEN WORKING OUTDOORS. FOR HOUSEHOLD USE ONLY. WARNING: CUT HAZARD. When turning the tool off for tube installation or any other reason, wait 10 seconds for the fan to stop rotating before disassembly.
• Do not use in vacuum mode without the vacuum tubes and collection bag in place.
• Always switch off and remove the plug from the electrical supply when:
• Changing from blower to vacuum.
• The power supply cord has become damaged or entangled.
• You leave blower/vac unattended.
• Clearing a blockage.
• Checking, adjusting, cleaning or working on blower/vac.
• Use blower/vac only in daylight or good artificial light.
ON/OFF SWITCH (FIGURE 10)
MODEL LH5000
Your blower vac is fitted with a variable speed switch located on the top of the power head below the handle.
• Toturn the tool ON, rotate the knob clockwise. The further the knob is rotated, the higher the air speed.
• Toturn tool OFF,rotate the knob counterclockwise to the off position (0).
MODEL LH4500
Your blower vac is fitted with a two speed switch located on the top of the power head below the handle.
• Touse in low speed, rotate the knob clockwise to Position I. Touse in high speed, rotate the knob clockwise to Position II.
• Toturn tool OFF,rotate the knob counterclockwise to the off position (0).
8 |
9 |
10 |
5
