English
•This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been give supervision or instruction concerning use of the appliance by a person responsible for their safety
•Children must be supervised to make sure that they do not play with the appliance.
•This unit must be attended in use
•Do not allow children to use the blender without supervision.
Before first use
•Before using the appliance for the first time ensure all packaging is removed.
•Clean all parts before use.
After use
•Switch off and remove the plug from the socket before leaving the appliance unattended and before changing, cleaning or inspecting any parts of the appliance.
•When not in use, the appliance should be stored in a dry place. Children should not have access to stored appliances.
Inspection and repairs
•Before use, check the appliance for damaged or defective parts. Check for breakage of parts, damage to switches and any other conditions that may affect its operation.
•Do not use the appliance if any part is damaged or defective.
•Have any damaged or defective parts repaired or replaced by an authorised repair agent.
•Before use, check the power supply cord for signs of damage, ageing and wear.
•Do not use the appliance if the power supply cord or mains plug is damaged or defective.
•If the
•Never attempt to remove or replace any parts other than those specified in this manual.
Warning symbols
The following symbols are used in this manual:
Do not immerse the appliance, cord set or plug in liquids
Denotes risk of personal injury or damage to the product in case of
manual.
Denotes risk of electric shock.
Electrical safety
This appliance is double insulated in accordance with EN 60335;
therefore no earth wire is required.
Always check that the power supply corresponds to the voltage on the rating
To avoid the risk of electric shock, do not immerse the cord, plug or
motor unit in water or other liquid.
Parts Identification (Fig A)
1 | Filler cap | 7 | Control dial |
2 | Lid | 8 | Foot |
3 | Jar | 9 | Grater |
4 | Blade assembly | 10 | Grinder |
5 | Seal | 11 | Grater lid |
6 | Motor housing | 12 | Grinder lid |