Yamaha Complete Guide for Your HTR Series Receiver

AUTO SETUP

3Make sure of the following check points before starting the AUTO SETUP operations.

•Speakers are connected appropriately.

•Supplied optimizer microphone is connected to this unit and placed appropriately.

•Headphones are disconnected from this unit.

•The room is sufficiently quiet.

•The video monitor connected to this unit is turned on.

4Set the operation mode selector to AMP and then press SET MENU to enter “SET MENU”.

The top “SET MENU” display appears in the OSD.

AMP
	SET MENU
SOURCE	MENU
TV	SRCH MODE
	SET MENU

.;AUTO ;MANUAL

.;SIGNAL

p p

5Press ENTER to enter “AUTO SETUP”.

The “AUTO:MENU” display appears in the OSD.

PRESET/CH

1 AUTO:MENU

.;;;;;;;AUTO

;;;;;CHECK

;;;CHECK

;;;;;;;CHECK

ENTER;;;;;;;NATURAL

7Press k / n repeatedly to select “WIRING”, “DISTANCE”, “SIZE”, “EQ”, or “LEVEL”.

PRESET/CH

	1 AUTO:MENU
	;;;;;;;AUTO
	.;;;;;CHECK
	;;;CHECK
ENTER	;;;;;;;CHECK
	;;;;;;;NATURAL
A-E/CAT.	;;;;;;CHECK
	p	p
	p	[

This unit performs the following checks:

Speaker wiring WIRING

Checks which speakers are connected and the polarity of each speaker.

Speaker distance DISTANCE

Checks the distance of each speaker from the listening position and adjusts the timing of each channel.

Speaker size SIZE

Checks the frequency response of each speaker and sets the appropriate low-frequency crossover for each channel.

Choices: CHECK, SKIP

•Select “CHECK” to automatically check and adjust the item.

•Select “SKIP” to skip the item and perform no adjustments.

Parametric equalizer level EQ

A-E/CAT.

;;;;;;CHECK

p	p
p	[

Adjusts the frequency and the parametric equalizer level of each channel to reduce coloration across the channels and create a cohesive sound field. This is particularly important if you use different brands or

6Press l / h to select “SETUP”.

PRESET/CH

ENTER

A-E/CAT.

Choices: AUTO, RELOAD

•Select “AUTO” to automatically run the entire “AUTO SETUP” procedure.

•Select “RELOAD” to reload the last “AUTO SETUP” settings and override the previous settings. When you select “RELOAD”, the previous auto setup result appears in the OSD. See step 7 on page 33 and carry out the operations.

Note

“RELOAD” is available only when you have previously run “AUTO SETUP” and confirmed the results.

32 En

sizes of speakers for some channels or have a room with unique sonic characteristics. In addition, the frequency response of each channel is adjusted in accordance with the sound output from your front speakers.

Choices: NATURAL, FLAT, FRONT, SKIP

•Select “NATURAL” to average out the frequency response of all speakers with higher frequencies being less emphasized. Recommended if the FLAT setting sounds a little harsh.

•Select “FLAT” to average the frequency response of all speakers. Recommended if all of your speakers are of similar quality.

•Select “FRONT” to adjust the frequency response of each speaker in accordance with the sound of your front speakers. Recommended if your front speakers are of much higher quality than your other speakers.

•Select “SKIP” to skip the selected item and perform no adjustments.