Yamaha HTR-6090 owner manual 108 En, Programming macro operations

REMOTE CONTROL FEATURES

■ Programming macro operations
		Note
You can program your own macro and use the macro
		“AGAIN” appears in the display window if you press a
programming feature to transmit several remote control
commands in sequence at the press of a button. Be sure to		button other than a macro button.
set up remote control codes or perform learning operations
	3 Press the buttons for the functions you want
before programming the macro.
		to include in the macro operation in
Notes		sequence.

•The default macro is not cleared when a new macro is programmed for a button. The default macro can be used again when the programmed macro is cleared.

•It is not possible to add a new signal (macro step) to the default macro. Programming a macro changes all macro contents.

•We do not recommend programming continuous operations such as volume control in a macro.

1Set the operation mode selector to AMP or SOURCE and then press MACRO using a ballpoint pen or similar object.

“MCR ?” appears in the display window on the remote control.

AMP

SOURCE

TV

or	MACRO
AMP
SOURCE
TV

Note

If you do not complete each of the following steps within 30 seconds, the macro programming mode will be automatically canceled. In this case, start over from step 1.

You can set up to 10 steps (10 functions). After you have set 10 steps, “FULL” appears and the remote control automatically exits the macro mode. The following example is for programming the following procedure:

Step 1 (“MCR 1”): Press DVD.

Step 2 (“MCR 2”): Press AV POWER.

Step 3 (“MCR 3”): Press SLEEP.

POWER	POWER	STANDBY	POWER	MCR 2: AV POWER
TV	AV	2		MCR 3: SLEEP
XM			SLEEP
		AUDIO SEL
PHONO	TUNER	CD	MULTI CH IN 3
V-AUX/DOCK CBL/SAT MD/TAPE			CD-R
DTV	VCR 1	DVR/VCR 2	DVD
			1	MCR 1: DVD

Indicates the number of macro steps entered

Flashes alternately so you can set the next step

2 Press the macro button you want to use to				Note
operate the macro.				To change the selected input area, press SELECT k / n.
The macro button name (ex. “M;DVD”) and the				Pressing the input selector buttons will program a macro step,
selected component name (ex. “DVD”) appear				whereas SELECT k / n only changes the selected input area.
alternately in the display window on the remote				4 Press MACRO again using a ballpoint pen or
control.
		STANDBY	POWER	similar object when the operation sequence
				you want to program is complete.
XM				Note
PHONO	TUNER	CD	MULTI CH IN	“ERROR” appears in the display window if you press more
				than one button simultaneously.
V-AUX/DOCK CBL/SAT MD/TAPE			CD-R
DTV	VCR 1	DVR/VCR 2	DVD

108 En