Yamaha HTR-6090 owner manual Setting the speaker impedance, 29 En, 6 MIN, 8 MIN, Speaker Imp

CONNECTIONS

Setting the speaker impedance

CAUTION

If you are to use 6 ohm speakers, set “SPEAKER IMP.” to “6ΩMIN” as follows BEFORE using this unit. 4 ohm speakers can be also used as the front speakers.

VOLUME

MAIN ZONE
	ZONE 2	ZONE 2
		CONTROLS
ON/OFF
	ON/OFF
ON
OFF			PRESET/TUNING	FM/AM	A/B/C/D/E	PRESET/TUNING/CH	MEMORY	TUNINIG MODE
MASTER			SEARCHMODE		CATEGORY			DISPLAY
OPTIMIZER MIC			EDIT
				PROGRAM			INPUT
								VIDEO AUX
PHONES	ENHANCER	NIGHT	PURE DIRECT STRAIGHT		TONE CONTROL	AUDIO SELECT		ZONE 2 ZONE 2 VOLUME
								INPUT
SILENT CINEMA			EFFECT

2,5 2,4 3

1Make sure this unit is turned off.

See page 30 for details about turning on or off this unit.

2Press and hold STRAIGHT on the front panel and then press MASTER ON/OFF inward to the ON position to turn on this unit.

This unit turns on, and the advanced setup menu appears in the front panel display.

STRAIGHT While holding down

EFFECT MASTER

3Rotate the PROGRAM selector on the front panel to select “SPEAKER IMP.”.

The following display appears in the front panel display.

PROGRAM

4Press STRAIGHT on the front panel repeatedly to select “6ΩMIN”.

The following display appears in the front panel display.

EFFECT

SPEAKER IMP.

6 MIN

5Press MASTER ON/OFF on the front panel to release it outward to the OFF position to save the new setting and turn off this unit.

MASTER

Note

The setting you made is reflected next time you turn on this unit.

PREPARATION

SPEAKER IMP.

8 MIN

29 En