4.Place the jug unit onto the power unit.
5.Connect it to the electrical supply and.select the required speed using the rotary switch.
The following settings are available:-
P = Pulse Operation
O = Power Off
1 = Low Speed
2 = High Speed
The appliance should be disconnected from the mains supply before removing
the jug.
The Blender should not be run for longer than 60 seconds. After 5 consecutive runs of 60 seconds use, the blender should be allowed to cool for at least 60 minutes before further use.
Useful advice
•Place the appliance on a clean, flat work surface.
•Add the ingredients to the jar then fit the lid
(2) and filler cap (1).
Note: Do not exceed the maximum capacity of 1.5 litres.
•Connect the appliance to a suitable electrical supply. Rotate the control dial (7) to the required speed.
•When blending is complete return the switch to the off (0) position.
•Once the blades have come to a complete stop, lift the jar from the motor housing.
•Remove the lid and pour the ingredients into a suitable container.
ENGLISH
Note: Ingredients can be added by inserting them through the hole left when the filler cap (1) is removed.
Warning! Never operate the Blender without the lid (2) fitted.
Maintenance & cleaning
•Switch the appliance off, remove the plug from the wall socket and wait until the blade has stopped rotating.
•The appliance is easier to clean if you do so immediately after use.
•Do not use abrasive cleaning agents, scourers, acetone, alcohol etc. to clean the appliance.
•All detachable parts are
•Place the detachable plastic parts on the top tray of the dishwasher. Make sure they are placed well away from the heating element.
•All removable parts can be cleaned with a cleaning brush in warm water with some
•Remove the dirty parts from the motor unit. Clean the motor unit with a damp cloth.
•Never immerse the motor unit in water nor rinse it under the tap.
Technical Data
Voltage | 220 – 240 Volts |
|
|
Supply | 50 – 60 Hz |
|
|
Power | 700W |
|
|
Weight | 2.2kg |
|
|
5
