maintenance
WARNING: For your own safety, turn switch "OFF" and remove plug from power source outlet before maintaining or lubricating your saw.
Do not allow sawdust to accumulate inside the saw.
Frequently blow out any dust that may accumulate inside the saw cabinet and the motor,
Frequently clean your cutting toolswith Craftsman Gum and Pitch Remover.
A coat of
If the power cord is worn or cut, or damaged in any way, have it replaced immediately.
Make sure the teeth of the
1. Remove Blade Guard.
\
\
2.Rotate Pawl toward rear of Spreader so that teeth are above top of Spreader.
3.Hold Spreader with left hand and place Pawl over corner of workbench.
4.Using a small round file (smooth cut) sharpen the teeth.
mubrication
The following parts should be oiled occasionally with
SAE No. 20 or No. 30 engine oil.
1.Tilt screw threads and pivot nut. (First clean with
Craftsman Gum and Pitch Remover.)
2.Elevation screw threads and pivot nut. (First clean with Craftsman Gum and Pitch Remover.)
3.Cradle bearing points.
4.Bearing points in Guard Assembly, Miter Gauge and
Rip Fence.
GUARD
t BEARING POINTS
sears recommends the following accessories
ITEM |
| CAT. NO. | |
Caster Sets | ............................... | or | |
7 In. Molding | Head Set | See Catalog | |
7 | In. Molding | Head | See Catalog |
8 In. Molding | Head | See Catalog | |
Molding/Dado Insert for 7 In. Dia. Molding |
| ||
| or Dado Head | ||
Molding/Dado Insert for 8 In. Dia. Molding |
| ||
| or Dado Head | ||
Work Light | See Catalog | ||
7 | In. Dia. Adjustable Dad0 Head | See Catalog | |
7 | In. Dia. Dado Head | See Catalog | |
Sanding Wheel | See Catalog | ||
ITEM | CAT. NO, |
Miter Gauge Stop Rods | |
Miter Gauge | |
Taper Jig | See Catalog |
Universal Jig | See Catalog |
Power Tool Know How Handbook |
Sears may recommend other accessories not listed in manual.
See your nearest Sears Store or Catalog Department for other accessories.
Do not use any accessory unless you have received and read complete instructions for its use.
43
