assembly
iNSTALLiNG BELT GUARD
Model 113.298721 & 113.298761
1.install three Clips (furnished with Guard) 90° apart starting with one Clip at the end of the Guard as shown. LONG END of Clip facing AWAY from you.
2.Reinstall Motor Pulley the same way it waswhen you aligned the Belt,
3.Place Belt on Saw Pulley. Insert end of Bell through opening in END of Guard.
4.Slip Belt over Motor Pulley.
5.Press Guard onto Support sothat bottom of Guard is approximately 3/4 inch away from Belt.
NOTE: To remove Guard, lift up on LONG TABS of
Clips, pull Guard outward. The Clips should remain on the Belt guard Support.
PLUGGING iN MOTOR
1.From among the loose parts find: 2 Wire Ties
OPENING
BELT GUARD
_CLIPS
N
LONG END
BELT
3/4 iN.
2.Route Motor Cord along dghtside ofcabinet and snap ties in 1/4 inch bole in side of cabinet. Secure cord in wire ties,
3.Plug Motor cord into outlet on side of switch box.
WIRE TIES
EXTENSION REMOVED FOR
PICTURE CLARITY
24
