Craftsman 113.298721, 113.298761 manual INSTALUNG RIGHT FRONT RiP FENCE GUIDE BAR, assembly

assembly

2.Insert two 3/4 inch screws though two flat washers then through holes in switch holes in switch.

3.Insert screws through holes eight and ten in front fence guide bar as illustrated.

4.Install two Iockwasher and nuts. Tighten nuts.

JAM NUT

5/16-18

LOCKWASHER

•.u,_.,, "_,.._ /8TH HOLE

J	".	GUIDE	BAR
IOTH HOLE	\
		FRONT	FENCE
	(UPSIDE		DOWN)
	%%'---	WASHER
	t
	HEX HEAD	SCREW
	5/16-18	x 3/4 IN.

INSTALUNG RIGHT FRONT RiP FENCE GUIDE BAR

1.From among the loose parts, find the following hard- ware;

*2 Hex Head Screws, 5/16-18 x 1-3/4"1 Hex Head Screws, 5/16-18 x 3/4

*4 Lockwashers, 5/16 External Type

*4 Hex Nuts 5/16-18

*3 Spacers, 3/4 diameter x 1/2 long "1 Hex Head Screw 5/16-18 x 1-1/4

*2 Flat Washers 5/8 x 1/16

1 Bracket

Items marked with an asterik (*) are shown actual size.

2.Put the bracket against the right edge of the right

5/16-18 x 1-!/4 iN

HEX HEAD SCREW 5/16 IN EXTERNAL 5/16 IN

LOCK WASHER HEX NUT

HEX HD. SCREW 5/16-18 x 3/4 IN

5/8 X 1/16 IN WASHER 3/4 IN, DIA. X 1/2 IN. .,_/	II
SPACER
BRACKET

extension so the bracket is lined up with the FIRST hole near the front of the extension. Insert a 3/4 long screw through a flat washer, through top hole in the bracket, and through the FIRST hole in the extension. Install a Iockwasher and nut on the screw. Tighten the

nutonly slightly.

3.Lay Guide Bars on saw table.

NOTE: The various holes in the Bar allow them to be positioned on the saw and also makes them adapt- able to other models.

4.Insert a 1-3t4 inch/ong screwthrough the THIRDhole

5.Place spacers on screws.

HEX NU

EXTERNAL

LOCKWASHER HEX HEAD

SCREW

5116-18 x 3/4	IN
	LEFT SIDE OF
	FRONT	GUIDE BAR
	(GUIDE	BAR I$ TO	BE
TTH HOLE	TURNED	END FOR	END

3RD HOLE AFTER SCREWS ARE INSTALLED)

SCREW

S/16-18 x 1-3/4 IN.

\

14