Craftsman 298721 assembly, Slide the Bars so that screwsare in the MIDDLE oft he slotted holes

assembly

6.Slide the Bars so that screwsare in the MIDDLE oft he slotted holes.

7.PositionRipFenceoverMiterGaugeGroove, holding

up the rear end while engaging front end with Bar. Lower Fence onto table.

8.Raise blade all the way up.

9.Carefully move Fence against blade.

10.Move Front Bar until "0" mark on Rip Scale is approximately in line with tip of Pointer.

11.Move Front Bar upwards until Fence is approxi-

mately 1/32 inch above table. l-_Jhtenscrew at left end of Bar.

NOTE: Fold a piece of newspaper making 8 thick- nesses and place between Rip Fence and table to act as a spacer. This will hold the Fence off of the table approximately 1/32 inch.

12.Adjust Rear Bar so that the Fence is approximately

1/32 inch above table, make sure it is square with Miter Gauge Groove. Tighten screw at end of Bar.

13.Move Fenceto RIGHTedge of table. Make sure it is approximately 1/32 inch above table at front and rear and tighten screws.

8THICKNESSES OF PAPER

8 THICKNESSES

16