![unpacking and checking contents](/images/new-backgrounds/197262/19726215x1.webp)
unpacking and checking contents
TOOLS NEEDED
Phillips Screwdriver
COMBINATION SQUARE MUST BE TRUE.
|
|
|
|
|
| STRAIGHT | EDGE | OF BOARD |
|
|
|
|
|
| 3/4" THICK. THIS EDGE MUST | ||
Medium | Screwdriver | DRAW | LIGHT | LINE | ON | BE PERFECTLY | STRAIGHT. | |
Small | Screwdriver | BOARD | ALONG | THIS | EDGE, |
|
|
I
Combination | Square |
| SIZE |
|
|
|
|
|
|
| Sot Screw | Wrenches |
|
|
|
|
|
|
| 3/32 | In. | SHOULD | BE | NO GAP | OR | OVERLAP |
Wrenches |
| 118 | in. | HERE | WHEN | SQUARE | IS | FLIPPED |
| 5/32 | in. | OVER IN | DOTTED | POSITION, | |||
7116 in. 112 In. 9/16 In. |
|
|
|
|
| |||
|
|
|
|
|
|
|
Separate all parts from packing materials and check each one with the illustratbn and the list of Loose Parts to make certain all items are accounted for, before discarding any packing material.
WARNING: If any parts are missing, do not attempt to assemblethe table saw, plug in the power cord or turn the switch or= until the missing parts are ob- tained and are Installed correctly.
Remove the protective oilthat is applied to the table top and edgesof thetable. Use anyordinary household type grease and spot remover.
WARNING: Toavoidfireor health hazard, never use gasoline, naptha, or similar highly volatile solvents. Apply a coat of automobile wax to the table.
Wipe all parts thoroughly with a clean, dry cloth. WARNING: Foryour own safety, neverconnect plug to power source outlet until a, assembly steps are complete, and you have read and understand the safety and operational Instructions.
M
ffEM | PART NAME | QTY. |
A | Blade Guard and Spreader | 1 |
B | Rip Fence | 1 |
C | Owner'sManual | 1 |
D | Cast Iron Table Extensions | 2 |
E | Miter Gauge | 1 |
H | Rip Fence Guide Bar with Rip Scale (Front). 1 | |
M | Support, Motor Base | 1 |
Q | Rip Fence Guide Bar (Rear) | 1 |
R | Side Stiffener | 2 |
S | Leg | 4 |
T | End Stiffener | 2 |
U | Motor | 1 |
| Bag of Loose Parts |
|
| (Containing the following items) |
|
G | Outlet, On/Off with Key | 1 |
J | Handwheel | 2 |
AM | Bracket, "L" Mounting (Model 113298721)... | 1 |
| Bag of Loose Parts | 3 |
| Bag of Loose Parts |
|
| (Containing the following items) |
|
F | Wrench | 1 |
K | Belt, "V" 1/2 x 41 | 1 |
L | Pulley, 1/2 dia. with 5/8 Bore | 1 |
N | Spreader, Rod | 1 |
0 | Blade Guard Support | 1 |
P | Spreader Support | 1 |
u
(MODEL 113.298761)
S
(MODEL 113.298721)