4.iMPORTANT:Measurethe distance from end of
Motor shaftto Pulley, Mark this dimension down; you will need it later when reinstalling the Pulley.
5.Make sure blade is 90°totable, raise it allthe way up.
6.Lift Motor untiledge ofwasher isevenwith end of slot tighten pivotscrew. Inthis position, pull Motor toward you (pins will slide out of Cradle) until Belt is TIGHT, tighten the two Motor Base Clamp Screws.
7.Loosen Pivot Screw slightly.
8.Lower the saw blade all the way down.
9.iMPORTANT: Motor should pivot freely down- ward as blade is lowered. If it does not, LOOSEN the Pivot Screw some more.
10.Pivot Screw must be adjusted only tight enough to allow Motor to pivot FREELY as blade is raised and lowered. This will maintain constant tension on Belt.
11.Put your hand around the belt half way between the two Pulleys and squeeze Belt until two sides of Belt touch, The Motorshould move freely as you squeeze the Belt. If Motor does not move freely, Belt tension must be readjusted.
=
INSTALUNG BELT GUARD
EDGE OF WASHER EVEN WITH END OF SLOT
SCREW
/
"L"BRACKET
MOTOR PULLEY
k MOTOR BASE
CLAMP SCREWS_
Model 113.298721
1.Remove the Belt and Motor Pulley.
2.Screws furnished with Guard are "Self Threading".
Screwthem into holesin BeltGuard SupportBracket, then remove them.
3.Position Belt Guard Support Bracket and Belt Guard Support as shown and install the screws. Make sure Motor shaft is in CENTER of hole in Support.
BELT GUARD
"L" BRACKET
TWO HOLES CLOSEST
TOGETHER
BELT GUARD
SUPPORT
PIVOT
oEL,oo,°o | |
SUPPO...ACKET | |
| |
BELT | GUARD SUPPORTSCREW |
INSTALLING BELT | GUARD |
Model 113.298761 | BELT GUARD |
| |
1.Remove the Belt and Motor Pulley.
2.Screws furnished with Guard are Serf Threading."
Screw them into holes in Belt Guard Support Bracket, then remove them,
3.Position Belt Guard Support Bracket and Belt Guard Support as shown and install the screws. Make sure Motor Shaft is in CENTER of hole in support.
\
PIVOT SCREW
'1 TWO HOLES CLOSEST TOGETHER
/
CENTERED
BELT GUARD
SUPPORT BRACKET
BELT GUARD SUPPORT
