Lucent Technologies Release 8.2 manual Install the C-LAN Circuit Pack, LAN Installation

E C-LAN Installation

Install the C-LAN Circuit Pack

Insert C-LAN Circuit Packs

The following sections describe the steps for installing the C-LAN circuit pack.

TCP/IP connections (10BaseT ethernet or ppp) require a TN799 C-LAN circuit pack. Complete the following steps to install these circuit packs.

1Determine the carrier/slot assignments of the circuit packs to be added. Both types of circuit pack can go into any port slot with the following exceptions —

The C-LAN circuit pack cannot be installed in the A carrier for

~the r model

~a duplicated si model

Administer the C-LAN Bus Bridge for csi models

Test the Packet Bus

and C-LAN Circuit

Pack

2Insert the circuit packs into the slots specified in step 1. You do not need to power down the cabinet to install a C-LAN circuit pack.

For the csi model only, complete the following steps to administer the Bus Bridge for the new C-LAN circuit pack.

Note: If there are 2 C-LAN circuit packs installed in this csi switch, administer the Bus Bridge for only one of them.

1Enter change system-parameters maintenance.

2At the bottom of Page 2, enter y in the Packet Intf2 field.

3Enter the location of the C-LAN circuit pack in the Bus Bridge field (for example, 01a08 for cabinet 1, carrier A, and slot 8).

4Enter the port bandwidths or use the defaults in the Pt0, Pt1, and Pt2 Inter-Board Link Timeslots fields.

5Submit the form.

6Verify that the bus bridge LED is lit on the C-LAN circuit pack. This indicates that the packet bus is enabled.

To test the packet bus and the TN799 C-LAN circuit pack, the cabinet needs a TN771D Maintenance/Test circuit pack.

1If there is no TN771D circuit pack in the cabinet, place one in a port slot.

2Enter test pkt port-network 1 long. For more information about these tests, refer to the “test pkt command” section in the maintenance book.

3If the TN771D circuit pack was already in the cabinet, leave it there.

4If you added the TN771D circuit pack to the cabinet in order to test the TN799 circuit pack, remove it from the cabinet.

		Administration for Network Connectivity
414	CID: 77730	555-233-504 — Issue 1 — April 2000