Lucent Technologies Release 8.2 manual Audix , dcs , fp-mwi , gateway, Gtwy-tcp , mis , msaamwl

Networking Screens		A Screens Reference
Appl.	Identifies the switch application used on this link.
	Valid entries	Usage
	audix, dcs, fp-mwi,gateway,	The gateway application is used for conversion
	gtwy-tcp,mis, msaamwl,	between ISDN and either TCP/IP or BX.25.
	msaclk, msahlwc, msallwc,	The gtwy-tcpapplication is used for
	msamcs, qsig-mwi, and blank	conversion between BX.25 and TCP/IP.
		These application types are used on the
		gateway switch only.

Gtwy To	Used for gtwy-tcpapplications only. Identifies the processor channel that this
	processor channel is serving as a gateway to.
	Valid entries		Usage
	1-128(csi model)		Two processor channels on the gateway switch are needed
	1-256(si model)		to set up a gtwy-tcpgateway, which converts between
	1-384(r model)		X.25 and TCP/IP protocols. For each of the two gtwy-tcp
			processor channels, the Gtwy To field points to the other
			gtwy-tcpprocessor channel.
			For example, if processor channels 5 and 17 are used for a
			gtwy-tcpgateway, Gtwy To for processor channel 5
			would be set to 17 and Gtwy To for processor channel 17
			would be set to 5.
Mode	Identifies whether the IP session is passive (client) or active (server).
	Valid	Usage
	entries
	c (client)	This field must be blank if the type of interface link is x.25 (r model)
	s (server)	or procr-intf (si model). This field cannot be blank if the type of
	blank	interface link is ethernet or ppp.
		Set the Mode to s for ppp or ethernet connections to CMS. Set
		opposite values (c<-->s) on the endpoints for ppp or ethernet
		connections between switches or between a switch and Intuity
		AUDIX.

		Administration for Network Connectivity
274	CID: 77730	555-233-504 — Issue 1 — April 2000