Lucent Technologies Release 8.2 manual Name entered on the Node Names screen

Configuration 2: R7r (+CMS) <—ethernet—> R7csi			3 C-LAN Administration
	Field	Conditions/Comments
	Destination Node	Name of the far-end node for this channel. This must be a
		name entered on the Node Names screen.
	Destination Port	A value of 0 allows any available interface channel on the
		destination node to be used for this connection. The Interface
		Channel number on the Switch-2 Processor Channel screen
		must also be set to 0.
	Session - Local	The Local and Remote Session numbers can be any value
		between 1 and 256 (si model) or 384 (r model), but they must
	Session - Remote
		be consistent between endpoints. For each connection, the
		Local Session number on this switch must equal the Remote
		Session number on the remote switch and vice versa.
		It is allowed, and sometimes convenient, to use the same
		number for the Local and Remote Session numbers. It is
		allowed, but not recommended, to use the same Session
		numbers for two or more connections.
	Mach ID	This field is not used for CMS.

Processor Channel 12: (ethernet connection to Switch 2)

	Enable	Set to y.
	Appl.	Enter dcs for the DCS connection on Processor Channel 12.
	Mode	Set the node-5 Mode field to c (“client”) on the Processor
		Channel Assignment screen on Switch 2.
	Interface Link	This must match the link number assigned on the node-1 data
		module screen.
	Interface Chan	For TCP/IP, interface channel numbers are in the range 5000
		– 64500.
		The recommended values are: 5001 for CMS, 5002 for Intuity
		AUDIX, and 5003 for DCS connections that are not
		gateways. These three values should be reused for multiple
		instances of these applications; for example, if there are two
		Intuity AUDIX’s, use 5002 for both; or if there are four
		DEFINITY ECS’s, use 5003 for all four. The combination of
		Link, Interface Channel, and Mach ID must be unique.
		The recommended values for gateway switches is 6001–6099.
		The interface channel number must be unique for each
		gateway.
	Destination Node	Name of the far-end node for this channel. This must be a
		name entered on the Node Names screen.
	Destination Port	A value of 0 allows any available interface channel on the
		destination node to be used for this connection. The Interface
		Channel number on the Switch-2 Processor Channel screen
		must also be set to 0.
		2 of 3
Administration for Network Connectivity
555-233-504 — Issue 1 — April 2000		CID: 77730	81