Lucent Technologies Release 8.2 manual Switch 2 Task Assign Processor Channels

Configuration 1: R8r <—ppp—> R8si 3 C-LAN Administration

Switch 2 Task — Assign Processor Channels

This task associates data links (hardware) with processor channels (software) on

Switch 2.

Steps

Begin

> Open the Processor Channel Assignment form — enter ch com p

change communications-interface processor-channels

Page 1 of X

PROCESSOR CHANNEL ASSIGNMENT

Proc			Gtwy		Interface	Destination		Session		Mach
Chan Enable		Appl.	To Mode	Link/Chan		Node	Port	Local/Remote		ID
1:	n	_______	_	__	_____	__________	0____	___	___	__
2:	n	_______	_	__	_____	__________	0____	___	___	__
:
21:	y	dcs ___	c	3_	0____	node-1____	5003	21_	12_	1_
:
64:	n	_______	_	__	_____	__________	0____	___	___	__

> Enter values

Field

Conditions/Comments

Processor Channel 21: (ppp connection to Switch 1)

Enable	Set to y.
Appl.	Set to dcs for DCS signaling.
Mode	Node-2 is the “client” for this session. Set node-1 to “server”
	(s).
Interface Link	This must match the link number on the node-2 data module
	screen in the previous task.
Interface Chan	A value of 0 allows any available interface channel to be used
	for this connection. The Destination Port number on the
	Switch-1 Processor Channel screen must also be set to 0.
Destination Node	Name of the far-end node for this channel. This must be a
	name entered on the Node Names screen. For ppp
	connections, it must match the Destination Node Name
	entered on the ppp Data Module screen.
Destination Port	This number must match the Interface Channel number
	assigned on the Switch-1 Processor Channel screen.
	1 of 2

		Administration for Network Connectivity
70	CID: 77730	555-233-504 — Issue 1 — April 2000