Lucent Technologies Release 8.2 manual Dte, isn, Establish Connection?, Connected Data Module

Networking Screens							A Screens Reference
Establish Connection?	Specifies whether this switch will be responsible for the call setup for this
	connection.
	Valid	Data		Usage
	Entries	Module
		Types
	y/n	procr-intf		Enter y if the System is responsible for any part of the call
	Default	x.25		setup for the link defined by this data module.
	is n.			If the physical link is through a pair of MPDMs or
				MTDMs, then each switch terminating the link must set
				up a connection between its Processor Interface Data
				Module and MPDM/MTDM.
				Enter the opposite value when administering the data
				module for switch at the other end of the connection.
				If the link is to be used for ISDN signaling, enter y.
Connected Data Module	This in an information-only field. This field displays when the Destination Number
	field is other than eia.
	Valid Entries				Data Module		Usage
					Types
	no entries — information				procr-intf
	only				x.25
Connected To	Specifies whether the connected device is dte or isn.
	Valid entries		Data Module			Usage
			Types
	dte, isn		pdm			Displays only when Type is pdm and the
						Destination Number is set to eia. Enter dte if
						the data module is connected to Data
						Terminal Equipment (DTE) or enter isn if
						connected to an Information Systems
						Network (ISN).
ITC	Information Transfer Capability. This field is used to determine the type of
	transmission facilities to be used for ISDN calls originating from this endpoint.
	Displays when Communication Type is 56k-data, 64k-data, or Wideband.
	Enter restricted (default) or unrestricted to indicate the type of transmission
	facilities to be used for ISDN calls originated from this endpoint. The field does not
	display for voice-only or BRI stations.
	When adding an access endpoint with the ITC administered as unrestricted, its
	associated port must be a channel of a DS1 circuit pack with zero code suppression
	administered as b8zs. If the port is not a channel of a DS1 circuit pack with its zero
	code suppression administered as b8zs, the end validation fails and the form
	submission is rejected.
							Administration for Network Connectivity
260				CID: 77730			555-233-504 — Issue 1 — April 2000