Lucent Technologies Release 8.2 manual 116 CID

Configuration 3: R8si<—x.25 —> R8r Gateway		3 C-LAN Administration
<—ethernet—> R8si
	Field	Conditions/Comments
	Session - Local	The Local and Remote Session numbers can be any value
		between 1 and 256 (si model) or 384 (r model), but they
	Session - Remote
		must be consistent between endpoints. For each
		connection, the Local Session number on this switch must
		equal the Remote Session number on the remote switch and
		vice versa.
		It is allowed, and sometimes convenient, to use the same
		number for the Local and Remote Session numbers. It is
		allowed, but not recommended, to use the same Session
		numbers for two or more connections.
	Mach ID	Destination switch ID identified on the dial plan of the
		destination switch. This is usually called the “node
		number.”

Processor Channel 23: (connection to Switch 1 for gateway to Switch 3)

	Enable	Set to y.
	Appl.	Set to dcs for DCS signaling.
	Mode	Used for TCP/IP connections only.
	Interface Link	This must match the link number assigned on the procr-intf
		data module screen.
	Interface Chan	The interface channel number must be in the range 1 – 64
		for an X.25 link.
	Destination Node	Used for TCP/IP connections only.
	Destination Port	Used for TCP/IP connections only.
	Session - Local	For each connection, the Local Session number on this
		switch must equal the Remote Session number on the
	Session - Remote
		remote switch and vice versa.
	Mach ID	Destination switch ID identified on the dial plan of the
		destination switch.
		2 of 2
> Submit the screen
End

		Administration for Network Connectivity
116	CID: 77730	555-233-504 — Issue 1 — April 2000