H.323 Trunk Administration

2 H.323 Trunks

IP Media Parameters

Each DEFINITY switch in an IP network has one IP Media Parameters screen. Use

 

this screen to enter:

 

 

~ the types of codecs (for audio processing) available on this switch

 

~ the preferred order of use of the codec types

 

 

~ the range of port numbers available for audio connections

 

Network Regions

The Region field on the IP Interfaces screen allows you to set up segregated groups of

 

C-LAN and IP Interface (Medpro) resources. This feature can be used in a variety of

 

ways. For example, you could use regions to allocate specific C-LAN and IP Interface

 

boards to H.323 trunks and others to stations; or you could use regions to avoid

 

multimedia traffic over low bandwidth or high-latency network links.

H.323 Trunk Administration — Task Detail

This section describes the tasks that need to be completed to administer an H.323 trunk. Sample values are used to populate the fields to show the relationships between the screens and fields.

Task 1 — Assign Node Names

This task assigns node names and IP addresses to each node in the network that this switch communicates with via IP connections. A Node Names screen must be administered on each DEFINITY switch in an IP network.

A node is defined as any of the following — a C-LAN ethernet or ppp port, a bridge or router, a CMS ethernet port, or an Intuity AUDIX or other MSA network interface card. The AUDIX and MSA node name and IP address must be entered on page 1 of the screen. The data for all other node types must be entered on pages 2–6.

For H.323 connections, each MedPro ethernet port (IP interface) on the local switch only must also be assigned a node name and IP address on this form.

The node names and IP addresses in any network should be assigned in a logical and consistent manner from the point of view of the whole network. These names and addresses should be assigned in the planning stages of the network and should be available from the customer system administrator or from a Lucent representative.

Note: Enter node names for Intuity AUDIX and MSA adjuncts on page 1. Enter node names for switches, routers, and CMS starting on page 2.

 

 

Administration for Network Connectivity

38

CID: 77730

555-233-504 — Issue 1 — April 2000

Page 58
Image 58
Lucent Technologies Release 8.2 manual Trunk Administration Task Detail, Task 1 Assign Node Names, Network Regions