Lucent Technologies Release 8.2 manual Switch 2 Task Assign Node Names

Configuration 1: R8r <—ppp—> R8si 3 C-LAN Administration

Switch 2 Task — Assign Node Names

This task assigns node names and IP addresses to each node in the network. This screen is administered on Switch 2. A Node Names screen must be administered on each switch in the network.

The node names and IP addresses in any network should be assigned in a logical and consistent manner from the point of view of the whole network. These names and addresses should be assigned in the planning stages of the network and should be available from the customer system administrator or from a Lucent representative.

Note: Enter node names for Intuity AUDIX and MSA adjuncts on page 1. Enter node names for switches, routers, and CMS starting on page 2.

Steps

Begin

> Open Node Names form — enter ch node-n> Go to page 2 of the screen

change node names

				Page 2 of 6
		NODE NAMES
Name		IP Address	Name	IP Address
default_________		0__.0__.0__.0__ __________________		___.___.___.___
node-1	__	192.168.10_.31_ _______________		___.___.___.___
node-2	___	192.168.10_.32_ _______________		___.___.___.___
________________		___.___.___.___ _______________		___.___.___.___
________________		___.___.___.___	_______________	___.___.___.___

> Enter values.

Field	Conditions/Comments
Name	Enter unique node names for the following 2 nodes:
	• C-LAN PPP port on Switch 2
	• C-LAN PPP port on Switch 1.
IP Address	The unique IP addresses of the nodes named in the previous
	field.
> Submit the screen
End

Administration for Network Connectivity
555-233-504 — Issue 1 — April 2000	CID: 77730	67