Lucent Technologies Release 8.2 manual Switch 1 Task Assign Processor Channels

Configuration 1: R8r <—ppp—> R8si

3 C-LAN Administration

Switch 1 Task — Assign Processor Channels

This task associates data links (hardware) with processor channels (software) on

Switch 1 and specifies the destination node and machine ID.

Steps

Begin

> Open the Processor Channel Assignment form — enter ch com p

change communications-interface processor-channels

Page 1 of X

PROCESSOR

CHANNEL ASSIGNMENT

Proc

Gtwy

Interface

Destination

Session

Mach

Chan Enable

Appl.

To Mode

Link/Chan

Node

Port

Local/Remote

ID

1:

n

_______

_

__

_____

__________

0____

___

___

__

2:

n

_______

_

__

_____

__________

0____

___

___

__

:

12:

y

dcs ___

s

1_

5003

node-2____

0____

12_

21_

2_

:

64:

n

_______

_

__

_____

__________

0____

___

___

__

> Enter values for processor channel 12

Field

Conditions/Comments

Enable

Set to y.

Appl.

Set to dcs for DCS signaling.

Mode

node-1 is the "server" for this session. Set node-2 to "client"

(c).

Interface Link

This must match the link number assigned on the node-1

data module screen in the previous task.

Interface Chan

For TCP/IP, interface channel numbers are in the range 5000

– 64500.

The recommended values are: 5001 for CMS, 5002 for

Intuity AUDIX, and 5003 for DCS connections that are not

gateways. These three values should be reused for multiple

instances of these applications; for example, if there are two

Intuity AUDIX’s, use 5002 for both; or if there are four

DEFINITY ECS’s, use 5003 for all four. The combination

of Link, Interface Channel, and Mach ID must be unique.

The recommended values for gateway switches is

6001–6099. The interface channel number must be unique

for each gateway.

This number must match the Destination Port number on the

node-2 Processor Channel screen.

1 of 2

Administration for Network Connectivity

555-233-504 — Issue 1 — April 2000

CID: 77730

65