Lucent Technologies Release 8.2 manual Valid Data Usage Entries Module Types

Networking Screens	A Screens Reference
COR	Class of restriction. COR identifies caller and called-party privileges for telephones,

telephone groups, data modules, and trunk groups.

	Valid		Data Module		Usage
	Entries		Types
	0-95		ppp		The values for these fields will be specified by
	Default is 1		procr-intf		the system administrator.
			x.25
					Administer the COR so that account codes are
			pdm
					not required. Forced entry of account codes is
					turned off for wideband endpoints.
TN	Tenant partition number. Enables a single DEFINITY ECS to appear to users as
	several small independent switches.
	Valid		Data	Usage
	Entries		Module
			Types
	1-20 (csi,		ppp	Partitioning could be useful when 2 or more user
	si)		procr-intf	groups (tenants) have different switch-usage patterns.
	1-100 (r)		x.25	For R6 and later configurations, all MASI trunks are
			pdm
				associated with Tenant 1.
	Default is 1
BCC	Bearer capability class. This field is not administrable on the data module screens.
	BCC is used with ISDN connections to identify the types of traffic that can be
	supported by a given trunk.
	Valid	Data Module		Usage
	Values	Types
	0-4	ppp		For non-ISDN connections, leave the default (2).
		ethernet		For ISDN connections,
		pdm
				0 = Voice only. Use for H.323 trunks.
				1 = Mode 1 data — allows restricted
				circuit-switched data on a B-channel; 56Kbps
				2 = Mode 2 data — 64 Kbps data packaged in an
				inverted HDLC protocol and limited to user data
				rates between 300bps and 19.2Kbps.
				3 = Mode 3 data — when circuit switched, 64Kbps
				digital data packaged in LAPD protocol.
				4 = Mode 0 data — a data bearer capability that
				allows full 64Kbps unrestricted circuit switched data
				on a B-channel. Also referred to as clear channel.

		Administration for Network Connectivity
258	CID: 77730	555-233-504 — Issue 1 — April 2000