Lucent Technologies Release 8.2 manual See CentreVu CMS Software Installation and Setup

Configuration 2: R7r (+CMS) <—ethernet—> R7csi 3 C-LAN Administration

Switch 1 Task — Assign Node Names

This task assigns node names and IP addresses to each node in the network. This screen is administered on Switch 1. A Node Names screen must be administered on each switch in the network.

The node names and IP addresses in any network should be assigned in a logical and consistent manner from the point of view of the whole network. These names and addresses should be assigned in the planning stages of the network and should be available from the customer system administrator or a Lucent representative.

Note: Enter node names for Intuity AUDIX and MSA adjuncts on page 1. Enter node names for switches, routers, and CMS starting on page 2.

Steps

Begin

> Open Node Names form — enter ch node-n> Go to page 2

change node names					Page 2 of 6
				NODE NAMES
Name		IP Address		Name	IP Address
default_________		0__.0__.0__.0__		_______________	___.___.___.___
node-1	__	192.168.1	_.124	_______________	___.___.___.___
node-2___		192.168.1	_.125	_______________	___.___.___.___
node-3__________		192.168.1	_.97_	_______________	___.___.___.___
node-5__________		192.168.1	_.51_	_______________	___.___.___.___

> Enter values.

Field	Conditions/Comments
Name:	Enter node names for the following 4 nodes:
	• node-1: C-LAN Ethernet port on Switch 1
	• node-2: CMS node (for consistency, use the host name of the
	CMS computer assigned during the CMS setup procedure —
	see CentreVu CMS Software Installation and Setup,
	585-215-866)
	• node-3: Interface on the router to the subnet of Switch 1.
	• node-5: C-LAN Ethernet port on Switch 2.
IP Address:	The unique IP addresses for the nodes named in the previous field.
	See the description of the Subnet Mask field in the next task for
	information on valid IP addresses.

> Submit the screen

End

		Administration for Network Connectivity
76	CID: 77730	555-233-504 — Issue 1 — April 2000