Lucent Technologies Release 8.2 manual For this connection. This number must match the Destination

Configuration 4: R8csi <—ISDN—> R8si Gateway	3 C-LAN Administration
<—ppp—> R8csi

Switch 3 Task — Assign Processor Channels

This task associates data links (hardware) with processor channels (software) on

Switch 3.

Steps

Begin

> Open the Processor Channel Assignment form — enter ch com p.

change communications-interface processor-channels

Page 1 of X

PROCESSOR CHANNEL ASSIGNMENT

Proc			Gtwy	Interface		Destination		Session		Mach
Chan Enable		Appl.	To Mode	Link/Chan		Node	Port	Local/Remote		ID
1:	n	_______	_	__	_____	_________	0____	___	___	__
2:	n	_______	_	__	_____	_________	0____	___	___	__
:
31:	y	dcs____	c	1_	0	node-1___	5003	31_	13_	1_
32:	y	dcs____	c	1_	0	node-1___	6002	32_	14_	2_
:
64:	n	_______	_	__	_____	_________	0____	___	___	__

> Enter values

Field

Conditions/Comments

Processor Channel 31: (ppp connection to Switch 1)

Enable	Set to y.
Appl.	Set to dcs for DCS signaling.
Mode	Node-3 is the “client” for this session. Set node-1 to “server”
	(s).
Interface Link	This must match the link number assigned on the node-3 data
	module screen.
Interface Chan	A value of 0 allows any available interface channel to be used
	for this connection. This number must match the Destination
	Port number on the Switch-1 Processor Channel screen.
Destination	Name of the far-end node for this channel. This must be a
Node	name entered on the Node Names screen. For ppp
	connections, it must match the Destination Node Name
	entered on the ppp Data Module screen.
Destination Port	This must match the Interface Channel number assigned on
	the Switch-1 Processor Channel screen.
	1 of 2

Administration for Network Connectivity
555-233-504 — Issue 1 — April 2000	CID: 77730	143