Lucent Technologies Release 8.2 manual Task 3 Assign Link via ethernet Data Module to the LAN

H.323 Trunk Administration 2 H.323 Trunks

Task 3 — Assign Link via ethernet Data Module to the LAN

This task administers an ethernet data module for the connection between the C-LAN board’s ethernet port (port 17) and the LAN. The data module associates a link number and extension number with the C-LAN ethernet port location. This association is used by the DEFINITY processor to set up and maintain signaling connections for multimedia call handling.

The C-LAN ethernet port is indirectly associated with the C-LAN IP address via the slot location (which is part of the port location) on the IP Interfaces screen and the node name, which is on both the IP Interfaces and Node Names screens.

Task 3 Steps

Begin
> Open Data Module form — enter		a da n
add data-module next			Page 1 of X
	DATA MODULE
Data Extension: 2377		Name: ethernet on link 2
	Type: ethernet
	Port: 01c0817_
	Link: 2
Network uses 1’s for broadcast addresses?: y
> Enter values
Field	Conditions/Comments
Type:	This indicates the data-module type (ethernet) for this link.
Port:	Ethernet connections must be assigned to port 17 on the C-LAN
	circuit pack.
Link:	The link number must be in the range 1 – 33 for G3r, or 1 – 25 for
	G3si and G3csi, and not previously assigned on this switch.
Name:	This field is information-only; it appears in lists generated by the
	“list data module” command.
Network	Leave the default (y) if the private network contains only
uses 1’s for	DEFINITY switches and adjuncts. Set to n only if the network
broadcast	includes non-DEFINITY switches that use the 0’s method of
addresses?	forming broadcast addresses. See Appendix A, “Data Module -
	type ethernet” for more information about this field.

> Submit the screen

End

		Administration for Network Connectivity
42	CID: 77730	555-233-504 — Issue 1 — April 2000