Lucent Technologies Release 8.2 manual Issue 1 April CID 155

Configuration 5A: R8csi <—ppp—> R8r (one C-LAN)			3 C-LAN Administration
<—ethernet—> R8si
	Field	Conditions/Comments
	Destination Node	Name of the far-end node for this channel. This must be a
		name entered on the Node Names screen. For ppp
		connections, it must match the Destination Node Name
		entered on the ppp Data Module screen.
	Destination Port	A value of 0 allows any available interface channel on the
		destination node to be used for this connection. The
		Interface Channel number for this connection on the
		Switch-2 Processor Channel screen must also be set to 0.
	Session - Local	The Local and Remote Session numbers can be any value
		between 1 and 256 (si model) or 384 (r model), but they
	Session - Remote
		must be consistent between endpoints. For each connection,
		the Local Session number on this switch must equal the
		Remote Session number on the remote switch and vice
		versa.
		It is allowed, and sometimes convenient, to use the same
		number for the Local and Remote Session numbers. It is
		allowed, but not recommended, to use the same Session
		numbers for two or more connections.
	Mach ID	Destination switch ID identified on the dial plan of the
		destination switch.

Processor Channel 13: (ethernet connection to Switch 3)

	Enable	Set to y.
	Appl.	Set to dcs for DCS signaling.
	Mode	Node-1-eth is the “server” for this session. Set node-3 to
		“client” ( c).
	Interface Link	This must match the link number assigned on the node-1b
		data module screen.
	Interface Chan	For TCP/IP, interface channel numbers are in the range
		5000 – 64500. The value 5003 is recommended for the DCS
		connections. This number must match the Destination Port
		number on the Switch-2 Processor Channel screen. (Note
		that 5003 can be used for the connections to both Switch 2
		and 3 because they are on different links).
	Destination Node	Name of the far-end node for this channel. This must be a
		name entered on the Node Names screen. For ppp
		connections, it must match the Destination Node Name
		entered on the ppp Data Module screen.
	Destination Port	A value of 0 allows any available interface channel on the
		destination node to be used for this connection. The
		Interface Channel number on the Switch-3 Processor
		Channel screen must also be set to 0.
		2 of 3
Administration for Network Connectivity
555-233-504 — Issue 1 — April 2000		CID: 77730	155