Lucent Technologies Release 8.2 manual Open Data Module form enter a da n

Configuration 5A: R8csi <—ppp—> R8r (one C-LAN)	3 C-LAN Administration
<—ethernet—> R8si

Switch 1 Task — Assign Link via ethernet Data Module to Ethernet

This task administers an ethernet data module for the ethernet connection to node 3. The data module associates a link number with a port address, extension number, and node name for the C-LAN port used for this connection.

Steps

Begin

> Open Data Module form — enter a da n

add data next

			Page 1 of X
	DATA MODULE
Data Extension: 2377		Name: ethernet on link 2		BCC: 2
Type: ethernet
Port: 01c0817_
Link: 2
Network uses 1’s for broadcast addresses? y
	> Enter values
	Field	Conditions/Comments
	Type:	This indicates the data-module type for this connection.
	Port:	Ethernet connections must be assigned to port 17 on the C-LAN
		circuit pack.
	Link:	The link number must be in the range 1 – 33 (for R8r), not
		previously assigned on this switch.
	Name:	Information-only; appears in list generated by the “list data
		module” command.
	Network uses	Leave the default (y) if the private network contains only
	1’s for	DEFINITY switches and adjuncts. Set to n only if the network
	broadcast	includes non-DEFINITY switches that use the 0’s method of
	addresses?	forming broadcast addresses. See Appendix A, “Data Module -
		type ethernet” for more information about this field.
	> Submit the screen
	End

Administration for Network Connectivity
555-233-504 — Issue 1 — April 2000	CID: 77730	153