Networking Screens

 

 

A Screens Reference

 

A message originating on Switch B destined for node 6 can use either route 2 or the

 

implied route. The switch will choose the implied route because it has metric 0 while

 

route 2 has metric 1. By using the implied route, the message goes directly from the

 

source to C-LAN2, without passing through C-LAN1. If route 2 had been

 

administered with metric 0, the switch may have used route 2, which goes through

 

C-LAN1 to C-LAN2. In this case, if traffic volume were high, the PPP connection

 

between C-LAN1 and C-LAN2 could be unnecessarily overloaded. Of course, any

 

destination-6 message already being handled by C-LAN1, such as a message from

 

Switch A, would have to use route 2.

 

The same description applies to route 3 and destination 1. There is an implied

 

metric-0route with destination 1 and gateway 2.

Route Type

The Route Type is a display-only field that appears on the screen when the change,

 

display, and list commands are used; it does not appear for the add command. It

 

specifies whether this is a network or host route.

 

A network route enables communications between the node specified in the C-LAN

 

Board field and all nodes on the (sub)network specified in the Destination Node field.

 

A host route enables communications between the node specified in the C-LAN

 

Board field and the single node specified in the Destination Node field.

 

For a network route, the node name in the Destination Node field must be

 

administered on the Node Names screen where it is associated with a (sub)network

 

address, not a specific node address. For example, 192.168.1.0 is the network address

 

for the 192.168.1 network.

 

The identification of an address as a network address or a host address depends on

 

how the network is subnetted, which is specified by the Subnet Mask field on the IP

 

Interfaces screen.

 

 

 

Valid Value

 

Usage

 

 

 

network or host

 

Display only.

 

 

 

 

 

 

Administration for Network Connectivity

254

CID: 77730

555-233-504 — Issue 1 — April 2000

Page 274
Image 274
Lucent Technologies Release 8.2 manual Route Type