Lucent Technologies Release 8.2 manual Bcc, Bearer Capability Class. This is a display-only field

Configuration 5A: R8csi <—ppp—> R8r (one C-LAN)	3 C-LAN Administration
<—ethernet—> R8si

Switch 2 Task — Assign Link via ppp Data Module to Switch 1

This task administers a ppp data module on Switch 2 for the ppp connection to Switch

1.The data module associates a link number with a port address, extension number, and node name for the C-LAN port used for this connection.

Steps

Begin

> Open Data Module form — enter ad da 3020

add data-module 3020
						Page 1 of x
			DATA MODULE
Data Extension: 3020					Name: _ppp on link 1 to node-1-ppp		BCC: 2
Type: ppp					COS: 1
Port: 01a0413					COR: 1
Link: 1_					TN: 1
Enable Link? n
Node Name: node-2___				_
Subnet Mask: 255.255.255.0
Establish Connection: n
DESTINATION
Digits:		___________
Node Name: node-1-ppp______
CHAP? n
> Enter values
	Field			Conditions/Comments
	Type:			This indicates the data-module type for this connection.
	Port:			In this example, the C-LAN circuit pack is in slot 01a04; the ppp
				connection is through port 13.
	Link:			The link number must be in the range 1 – 25 (for R8csi), not
				previously assigned on this switch
	Enable Link?			If you need to add an IP route that uses this node as a gateway,
				this field must be set to y before adding the IP route. Otherwise
				leave this field set to n until the link administration is complete;
				that is, until after all data modules and the processor channels are
				assigned, then set to y.
	Name:			Information-only; appears in list generated by the “list data
				module” command.
	BCC:			Bearer Capability Class. This is a display-only field.
							1 of 2
Administration for Network Connectivity
555-233-504 — Issue 1 — April 2000					CID: 77730		159