Lucent Technologies Release 8.2 manual Name IP Address Default Node-1-eth 192 Node-2 Node-3

Configuration 5A: R8csi <—ppp—> R8r (one C-LAN)	3 C-LAN Administration
<—ethernet—> R8si

Switch 3 Task — Assign Node Names

This task assigns node names and IP addresses to each node in the network. This screen is administered on Switch 3. A Node Names screen must be administered on each switch in the network.

The node names and IP addresses in any network should be assigned in a logical and consistent manner from the point of view of the whole network. These names and addresses should be assigned in the planning stages of the network and should be available from the customer system administrator or from a Lucent representative.

Note: Enter node names for Intuity AUDIX and MSA adjuncts on page 1. Enter node names for switches, routers, and CMS starting on page 2.

Steps

Begin

> Open Node Names form — enter ch node-n> Go to page 2

change node-names

			Page 2 of 6
	NODE NAMES
Name	IP Address	Name	IP Address
default_________	0__.0__.0__.0__	_______________	___.___.___.___
node-1-eth	192.168.10_.128	_______________	___.___.___.___
node-2___	192.168.10_.12_	_______________	___.___.___.___
node-3	192.168.10_.129	_______________	___.___.___.___
________________	___.___.___.___	_______________	___.___.___.___

> Enter values.

Field	Conditions/Comments
Name	Enter unique node names for the following 3 nodes:
	• C-LAN Ethernet port on Switch 3
	• C-LAN Ethernet port on Switch 1.
	• C-LAN PPP port on Switch 2
IP Address	The unique IP addresses of the nodes named in the previous field.

> Submit the screen

End

		Administration for Network Connectivity
164	CID: 77730	555-233-504 — Issue 1 — April 2000