Lucent Technologies Release 8.2 manual Configurations

Overview			3 C-LAN Administration
	✔	Checklist Item
		10	Signaling group administered
			~ page 1 — Trunk board address and Interface ID
			~ Page 2 — Administered NCA TSC assignment
		11	Synchronization plan administered
		12	Trunk groups assigned
		13	Dial plan administered
		14	Uniform dial plan administered
		15	AAR analysis administered
		16	Route pattern administered
		17	Hunt groups assigned
			3 of 3

Configurations

The task descriptions are presented in six relatively simple configurations. Each configuration describes how to administer either a 2-switch connection or a 3-switch gateway connection. The procedures for administering these configurations can be used either individually or in groups as “building blocks” for constructing most networks involving DEFINITY ECS R8 and pre-R7 switches.

The following table lists the configurations described in this chapter.

Config-	Switch	Connection	Switch	Connection	Switch	Page
uration	2	1	1	2	3
1	R7si	ppp	R7r			page 60
2	R7csi	ethernet	R7r			page 73
			(+CMS)
3	si	bx.25	R7r	ethernet	R7si	page 99
4	csi	isdn	R7si	ppp	R7csi	page 124
5A	R7csi	ppp	R7r	ethernet	R7si	page 146
5B	R7csi	ppp	R7r	ethernet	R7si	page 171
			(2 C-LAN
			boards)

The first 2 configurations are simple 2-switch networks. The next two are 3-switch networks with Switch 1 serving as a gateway between different signaling types for connection 1 and connection 2. The last two configurations are ppp–ethernet networks; 5B, is the same as 5A except the Switch 1 has two C-LAN boards instead of one.

		Administration for Network Connectivity
56	CID: 77730	555-233-504 — Issue 1 — April 2000