Lucent Technologies Release 8.2 manual 126 CID

Configuration 4: R8csi <—ISDN—> R8si Gateway	3 C-LAN Administration
<—ppp—> R8csi

Switch 1 Task — Assign Node Names

This task assigns node names and IP addresses to each node in the network. This screen is administered on Switch 1. A Node Names screen must be administered on each switch in the network.

The node names and IP addresses in any network should be assigned in a logical and consistent manner from the point of view of the whole network. These names and addresses should be assigned in the planning stages of the network and should be available from the customer system administrator or from a Lucent representative.

Note: Enter node names for Intuity AUDIX and MSA adjuncts on page 1. Enter node names for switches, routers, and CMS starting on page 2.

Steps

Begin

> Open Node Names form — enter ch node-n> Go to page 2.

change node-names

				Page 2 of 6
			NODE NAMES
Name		IP Address	Name	IP Address
default_________ 0__.0__.0__.0__			_______________	___.___.___.___
node-1	__	192.168.10_.101	_______________	___.___.___.___
node-3___		192.168.10_.103	_______________	___.___.___.___
________________		___.___.___.___	_______________	___.___.___.___

> Enter values.

Field	Conditions/Comments
Name	Enter unique node names for the following 2 nodes:
	• C-LAN PPP port on Switch 1
	• C-LAN PPP port on Switch 3.
IP Address	The unique IP addresses of the nodes named in the previous
	field.
> Submit the screen
End

		Administration for Network Connectivity
126	CID: 77730	555-233-504 — Issue 1 — April 2000