Lucent Technologies Release 8.2 manual Switch 2 Task- Assign Processor Channels

Configuration 2: R7r (+CMS) <—ethernet—> R7csi 3 C-LAN Administration

Switch 2 Task— Assign Processor Channels

This task associates data links (hardware) with processor channels (software) on

Switch 2.

Steps

Begin

> Open the Processor Channel Assignment form — enter ch com p

change communications-interface processor-channels

Page 1 of X

PROCESSOR CHANNEL ASSIGNMENT

Proc			Gtwy		Interface	Destination		Session		Mach
Chan Enable Appl.			To Mode	Link/Chan		Node	Port	Local/Remote		ID
1:	y	mis____	s	5_	5001__	node-2____ 0____		1 _	1__	__
2:	n	_______	_	__	_____	__________	0____	___	___	__
3:	n	_______	_	__	_____	__________	0____	___	___	__
4:	n	_______	_	__	_____	__________	0____	___	___	__
:
21:	y	dcs ___	c	5_	0	node-1____	5003_	21_	12_	1_
:
64:	n	_______	_	__	_____	__________	0____	___	___	__

> Enter values

Field

Conditions/Comments

Processor Channel 1: (connection to CMS)

Enable	Set to y.
Appl.	Enter mis for the CMS connection on Processor Channel 1.
Mode	Set the Mode to s (“server”) on both switches for connections
	to CMS.
Interface Link	This must match the link number assigned on the node-5 data
	module screen on this switch.
Interface Chan	For TCP/IP, interface channel numbers are in the range 5000
	– 64500.
	The recommended values are: 5001 for CMS, 5002 for Intuity
	AUDIX, and 5003 for DCS connections that are not gateways.
	These three values should be reused for multiple instances of
	these applications; for example, if there are two Intuity
	AUDIX’s, use 5002 for both; or if there are four DEFINITY
	ECS’s, use 5003 for all four. The combination of Link,
	Interface Channel, and Mach ID must be unique.
	The recommended values for gateway switches is 6001–6099.
	The interface channel number must be unique for each
	gateway.
	1 of 3

		Administration for Network Connectivity
90	CID: 77730	555-233-504 — Issue 1 — April 2000