Lucent Technologies Release 8.2 manual Name IP Address Default Node-1 192 Node-3

Configuration 3: R8si<—x.25 —> R8r Gateway	3 C-LAN Administration
<—ethernet—> R8si

Switch 1 Task — Assign Node Names

This task assigns node names and IP addresses to each node in the network. This screen is administered on Switch 1. A Node Names screen must be administered on each switch in the network.

A node is defined as any of the following — a C-LAN port, a bridge or router, a CMS ethernet port, or an Intuity AUDIX or other MSA network interface card. The Audix and MSA node name and IP address must be entered on page 1 of the screen. The data for all other node types must be entered on pages 2–6.

The node names and IP addresses in any network should be assigned in a logical and consistent manner from the point of view of the whole network. These names and addresses should be assigned in the planning stages of the network and should be available from the customer system administrator or from a Lucent representative.

Note: Enter node names for Intuity AUDIX and MSA adjuncts on page 1. Enter node names for switches, routers, and CMS starting on page 2.

Steps

Begin

> Open Node Names form — enter ch node-n> Go to page 2.

change node-names

				Page 2 of 6
			NODE NAMES
Name		IP Address	Name	IP Address
default________		0__.0__.0__.0__	_______________	___.___.___.___
node-1	__	192.168.10_.1__	_______________	___.___.___.___
node-3___		192.168.10_.3__	_______________	___.___.___.___
_____________ _		___.___.___.___	_______________	___.___.___.___

> Enter values.

Field	Conditions/Comments
Name	Enter unique node names for the following 2 nodes:
	• C-LAN Ethernet port on Switch 1
	• C-LAN Ethernet port on Switch 3.
IP Address	The unique IP addresses of the nodes named in the previous
	field.
> Submit the screen
End

Administration for Network Connectivity
555-233-504 — Issue 1 — April 2000	CID: 77730	101