Lucent Technologies Release 8.2 manual ~ Async. Transfer Mode ATM Trunking field is y

QSIG B Private Networking

3Enter display system-parameterscustomer-optionson the command line of your system administration screen.

4On page 1, verify fields as follows:

~G3 Version field is V8 or later.

5If the system is using ATM for QSIG, go to page 2 and verify the following field:

~Async. Transfer Mode (ATM) Trunking field is y.

6On page 3, verify fields as follows:

If the system is using ISDN-BRI for QSIG:

~ISDN-BRI Trunks field is y.

If the system is using ISDN-PRI for QSIG:

~ISDN-PRI field is y.

If the system is using QSIG Supplementary Services with or without Rerouting:

~Restrict Call Forward Off Net field is n.

7On page 4, verify fields as follows:

~ Basic Call Setup field is y.

If the system is using QSIG Supplementary Services:

~Basic Supplementary Services field is y.

If the system is using QSIG Supplementary Services with Rerouting:

~Supplementary Services with Rerouting field is y. If the system is using QSIG VALU:

~Value-Added Lucent (VALU) field is y.

8(For ISDN-PRI only). Administer or check the QSIG DS-1 circuit pack (see Appendix A). Check for the following field entries:

•Connect field - pbx

•Interface - peer-master or peer-slave

•Peer protocol - q-sig

•Signaling mode - isdn-prior isdn-ext

•Channel Numbering - sequential or timeslot (This item must match between the local switch and receiving switch.)

9(For ISDN-BRI only). Administer or check the QSIG ISDN-BRI circuit pack (see Appendix A).

		Administration for Network Connectivity
372	CID: 77730	555-233-504 — Issue 1 — April 2000