Lucent Technologies Release 8.2 manual ~ Set Network Level field is, ~ Call Type field is lev0

Centralized Voice Mail Via Mode Code B Private Networking

10On page 2, verify fields as follows:

~Leave Word Calling Send a Message field is #90.

~Leave Word Calling Cancel a Message field is #91.

Note: All nodes in the system and the Voice Mail system must match this setting

11For each DEFINITY node, enter add ds1UUCSS on the command line, where UUCSS is the address of the DS1 circuit pack.

12On page 1, verify fields as follows:

~Line Code field is B8ZS.

~Framing field is extended superframe.

~Signaling Mode field is ISDN/PRI.

~Connect field is PBX.

~Interface field is network (for the hub) and user (for the remote switch).

Note: Mode Codes will not work with D4 or SuperFrame

13For each DEFINITY node, enter change sign next on the command line. Administer the signaling group (see example in Chapter 4 of this document).

14For each DEFINITY node, enter change isdn private-numbering, and verify fields as follows:

~Set Network Level field is 0

This setting overrides the signaling on the D channel, allowing the Message Waiting lamp activation signal to be sent

15On the DEFINITY node, enter change sys params mode-codeon the command line.

16On the hub switch, set the VMS Hunt Group Extension field to the voice mail hunt group extension.

17On the remote switches, repeat Step 15. Enter the voice mail hunt group extension in the Remote VMS Extension - First field.

18For each DEFINITY node, enter change aar an on the command line.

19Verify the following:

~Call Type field is lev0

20On the hub switch, enter change station extension for each port extension in the voice mail hunt group.

21On Page 1, verify the following:

~Type field is vmi.

		Administration for Network Connectivity
398	CID: 77730	555-233-504 — Issue 1 — April 2000