Configuration 5B: R8csi <—ppp—> R8r (2 C-LANs)

3 C-LAN Administration

<—ethernet—> R8si

 

Switch 1 Task — Assign IP Route: C-LAN(b) to node-2

This task specifies a route for packets handled by C-LAN(b) destined for node-2. This route is needed because node-1b and node-2 are connected via ppp and there are intermediate nodes between them.

Steps

Begin

> Enable the ppp link on the node-1b data module screen:

ch da 2378, set Enable Link? to y.

> Open the IP Routing form — enter a ip n

 

add ip-route next

 

 

Page 1 of

1

 

 

 

 

IP ROUTING

 

 

Route Number: 3

 

 

Destination Node: node-2____

 

 

Gateway: node-1a

 

 

 

 

 

 

 

 

C-LAN Board: 1c08

 

 

Metric: 1

 

 

 

 

 

 

 

[The system assigns the route number 3.]

 

> Enter values

 

 

 

 

 

 

 

 

 

 

Field

 

Conditions/Comments

 

 

 

 

 

 

 

Destination Node:

 

The name of the node at the destination of this route.

 

 

 

 

 

 

Gateway:

 

Node name of the gateway by which the destination node

 

 

 

is reached for this route.

 

 

 

 

 

 

C-LAN Board:

 

The location of the C-LAN circuit pack that provides the

 

 

 

interface for this route.

 

 

 

 

 

 

Metric:

 

Enter 1, which indicates a complex route involving two

 

 

 

C-LAN boards.

 

 

 

 

See IP Routing (page 251) in Appendix A for more

 

 

 

 

information on the use of the Metric field.

 

 

 

 

 

 

 

 

> Submit the screen

 

 

 

 

End

 

 

 

 

 

 

 

 

 

 

 

 

 

Administration for Network Connectivity

188

CID: 77730

555-233-504 — Issue 1 — April 2000

Page 208
Image 208
Lucent Technologies Release 8.2 manual Switch 1 Task Assign IP Route C-LANb to node-2