Lucent Technologies Release 8.2 manual For this connection. The Destination Port number on

Configuration 2: R7r (+CMS) <—ethernet—> R7csi			3 C-LAN Administration
	Field	Conditions/Comments
	Destination	Name of the far-end node for this channel. This must be a
	Node	name entered on the Node Names screen.
	Destination Port	A value of 0 allows any available interface channel on the
		destination node to be used for this connection. The Interface
		Channel number on the Switch-2 Processor Channel screen
		must also be set to 0.
	Session - Local	The Local and Remote Session numbers can be any value
		between 1 and 256 (si model) or 384 (r model), but they must
	Session -
		be consistent between endpoints. For each connection, the
	Remote
		Local Session number on this switch must equal the Remote
		Session number on the remote switch and vice versa.
		It is allowed, and sometimes convenient, to use the same
		number for the Local and Remote Session numbers. It is
		allowed, but not recommended, to use the same Session
		numbers for two or more connections.
	Mach ID	This field is not used for CMS.

Processor Channel 21: (ethernet connection to Switch 1)

Enable	Set to y.
Appl.	dcs indicates that this connection will carry DCS data.
Mode	Node-5 will be the “client” on this session. Set node-1 (on
	Switch 1) to “server” ( s).
Interface Link	This must match the link number assigned on the node-5 data
	module screen.
Interface Chan	A value of 0 allows any available interface channel to be used
	for this connection. The Destination Port number on the
	Switch-1 Processor Channel screen must also be set to 0.
Destination	Name of the far-end node for this channel. This must be a
Node	name entered on the Node Names screen.
Destination Port	This number must match the Interface Channel number
	assigned on the Switch-1 Processor Channel screen.
	2 of 3

Administration for Network Connectivity
555-233-504 — Issue 1 — April 2000	CID: 77730	91