Lucent Technologies Release 8.2 manual Switch 3 Task Assign Link via ppp Data Module to Switch

Configuration 4: R8csi <—ISDN—> R8si Gateway	3 C-LAN Administration
<—ppp—> R8csi

Switch 3 Task — Assign Link via ppp Data Module to Switch 1

This task administers a ppp data module on Switch 3 for the ppp connection to Switch

1.The data module associates a link number with a port address, extension number, and node name for the C-LAN port used for this connection.

Steps

Begin

> Open Data Module form — enter ad da n

add data-module next

Page 1 of x

	DATA MODULE
Data Extension: 2801				Name: _ppp on link 1 to node-1___	BCC: 2
Type: ppp				COS: 1
Port: 01a0906				COR: 1
Link: 1_				TN: 1
Enable Link? n
Node Name: node-3			____
Subnet Mask: 255.255.255.0
Establish Connection: n
DESTINATION
Digits:		________
Node Name: node-1_________
CHAP? n
[This data module is assigned the extension 2801; you can assign any unused
extension in the dial plan.]
> Enter values
	Field			Conditions/Comments
	Type:			This indicates the data-module type for this connection.
	Port:			In this example, the C-LAN circuit pack is in slot 01a09; the
				ppp connection is through port 06.
	Link:			The link number must be in the range 1 – 25 (for R8csi), not
				previously assigned on this switch.
	Enable Link?			If you need to add an IP route that uses this node as a
				gateway, this field must be set to y before adding the IP route.
				Otherwise leave this field set to n until the link administration
				is complete; that is, until after all data modules and the
				processor channels are assigned, then set to y.
	Name:			Information-only; appears in list generated by the “list data
				module” command.
					1 of 2
Administration for Network Connectivity
555-233-504 — Issue 1 — April 2000				CID: 77730	141