Lucent Technologies Release 8.2 manual Digits Node Name node-2 CHAP? n

Configuration 5A: R8csi <—ppp—> R8r (one C-LAN)	3 C-LAN Administration
<—ethernet—> R8si

Switch 1 Task — Assign Link via ppp Data Module to Switch 2

This task administers a ppp data module on Switch 1 for the ppp connection to Switch

2.The data module associates a link number with a port address, extension number, and node name for the C-LAN port used for this connection.

Steps

Begin

> Open Data Module form — enter ad da 2376

add data-module 2376
				Page 1 of x
	DATA MODULE
Data Extension: 2376				Name: _ppp on link 1 to node-2___	BCC: 2
Type: ppp				COS: 1
Port: 01c0815				COR: 1
Link: 1_				TN: 1
Enable Link? n
Node Name: node-1-ppp		_
Subnet Mask: 255.255.255.0
Establish Connection: y
DESTINATION
Digits: 8993020_________
Node Name: node-2__________
CHAP? n
> Enter values
	Field		Conditions/Comments
	Type:		This indicates the data-module type for this connection.
	Port:		In this example, the C-LAN circuit pack is in slot 01c08; the
			ppp connection is through port 15.
	Link:		The link number must be in the range 1 – 33 (for R8r), not
			previously assigned on this switch.
	Enable Link?		If you need to add an IP route that uses this node as a gateway,
			this field must be set to y before adding the IP route. Otherwise
			leave this field set to n until the link administration is complete;
			that is, until after all data modules and the processor channels
			are assigned, then set to y.
	Name:		Information-only; appears in list generated by the “list data
			module” command.
	BCC:		Bearer Capability Class. This is a display-only field.
					1 of 2
Administration for Network Connectivity
555-233-504 — Issue 1 — April 2000				CID: 77730	149