Lucent Technologies Release 8.2 manual Entered on the ppp Data Module screen

Configuration 5B: R8csi <—ppp—> R8r (2 C-LANs)

3 C-LAN Administration

<—ethernet—> R8si

Switch 2 Task — Assign Processor Channels

This task associates data links (hardware) with processor channels (software) on

Switch 1.

Steps

Begin

> Open the Processor Channel Assignment form — enter

ch com p

change communications-interface processor-channels

Page 1 of X

PROCESSOR CHANNEL ASSIGNMENT

Proc

Gtwy

Interface

Destination

Session

Mach

Chan Enable

Appl.

To Mode

Link/Chan

Node

Port

Local/Remote

ID

1:

n

_______

_

__

_____

_____________

0____

___

___

__

2:

n

_______

_

__

_____

_____________

0____

___

___

__

3:

n

_______

_

__

_____

_____________

0____

___

___

__

4:

n

_______

_

__

_____

_____________

0____

___

___

__

:

21:

y

dcs ___

c

1_

0

_

node-1a-ppp__

5003_

21_

12_

1_

23:

y

dcs ___

c

1_

0

_

node-3_______

5003_

23_

32_

3_

:

64:

n

_______

_

__

_____

_____________

0____

___

___

__

> Enter values

Field

Conditions/Comments

For Processor Channel 21: (ppp connection to Switch 1)

Enable

Set to y.

Appl.

Set to dcs for DCS signaling.

Mode

Node-2 is the “client” for this session. Set node-1a to

“server” ( s).

Interface Link

Must match the link number assigned on the node-2 data

module screen.

Interface Chan

A value of 0 allows any available interface channel to be

used for this connection. The Destination Port number on

the Switch-1 Processor Channel screen must also be set to

0.

Destination Node

Name of the far-end node for this channel. This must be a

name entered on the Node Names screen. For ppp

connections, it must match the Destination Node Name

entered on the ppp Data Module screen.

Destination Port

This number must match the Interface Channel number

assigned on the Switch-1 Processor Channel screen.

1 of 2

Administration for Network Connectivity

555-233-504 — Issue 1 — April 2000

CID: 77730

193